Skip to content

Surface roughness and finish symbols on drawings

Below you will find what each symbol means and which Ra matches each process. In the editor you can place the roughness symbol on the surface or on its dimension.

NOTES1. Dimensions in mm.GETGCODE · PLANO TÉCNICOMATERIAL-GENERAL TOLERANCE-SCALE1:1TITLEDOCUMENT TYPEComponent drawingCREATED BY-APPROVED BY-DATE OF ISSUE2026-11-18REV.-SHEET1/1123456ABCDgetgcode.comA4

Line · 1/2Click the start point · Click the start and the end (or drag). It snaps to corners, midpoints, centres and intersections; with Shift, straight horizontal or vertical.

Guide

How to call out surface roughness on a machining drawing

Roughness states how fine a surface has to be. Asking for more than needed makes the part more expensive, because it forces another pass or grinding; asking for less can make a bearing or a seal fail. That is why it is stated surface by surface, not as one fine value for everything.

1

The three symbols

The basic symbol is two strokes shaped like a check mark resting on the surface. Closed with a horizontal bar to form a triangle, the surface must be machined by material removal. With an inscribed circle, material removal is not allowed: the surface stays as cast, forged or rolled.

2

The value: Ra in micrometers

The parameter and its value in micrometers go next to the symbol, for example «Ra 1.6». Ra is the mean deviation of the profile and the most used on the shop floor. Rz measures peak-to-valley height and gives larger values for the same surface, so the two cannot be swapped.

3

Which Ra to ask for

As a guide: Ra 12.5 and 6.3 for roughing and non-functional surfaces; Ra 3.2 for normal turning or milling, the most common general finish; Ra 1.6 for a fine finish and seating faces; Ra 0.8 for bearing seats and precise fits, often already ground; Ra 0.4 and below, grinding or honing.

4

Where it goes

On the surface line or on its dimension line, resting on the outside of the material and readable from the bottom or the right. If nearly the whole part has the same finish, state it once next to the title block as the general finish and mark only the surfaces that differ.

Frequently asked questions

Surface roughness symbols FAQ

What do N6, N7 and N8 mean?

They are the roughness grades from ISO 1302:1992; the 2002 edition dropped them, but they are still on many drawings. N6 equals Ra 0.8; N7 Ra 1.6; N8 Ra 3.2 and N9 Ra 6.3. Each grade doubles the previous value.

What do the old triangle symbols mean?

More triangles mean a better finish: one is roughing, two normal machining, three a fine finish and four a superfinish. They have no single Ra equivalent: published tables disagree (two triangles show as Ra 3.2 in some and Ra 1.6 in others). On an old drawing, ask the customer or use their company table; on a new drawing, state the Ra value.

Are Ra and Rz the same?

No. For the same machined surface Rz is several times larger than Ra, roughly four to eight times depending on the process, with no fixed factor. If a drawing asks for Rz, measure Rz; converting it to Ra by eye leads to errors.

Which standard defines these symbols?

For years it was ISO 1302, withdrawn at the end of 2021. It is replaced by ISO 21920-1:2021, which keeps the shape of the symbol and adds a bar above it to show which of the two standards applies. Most drawings in circulation still follow ISO 1302.

What roughness does turning leave?

It depends on feed and insert nose radius: lower feed and larger radius give a better finish. The roughness calculator gives the theoretical Ra before you cut.

Keep going

Related apps