Skip to content

Below are the rules for drawing and dimensioning external and internal threads. You can add them to your drawing in the editor: the hole note has a field for the thread and its depth.

NOTES1. Dimensions in mm.GETGCODE · PLANO TÉCNICOMATERIAL-GENERAL TOLERANCE-SCALE1:1TITLEDOCUMENT TYPEComponent drawingCREATED BY-APPROVED BY-DATE OF ISSUE2026-11-18REV.-SHEET1/1123456ABCDgetgcode.comA4

Line · 1/2Click the start point · Click the start and the end (or drag). It snaps to corners, midpoints, centres and intersections; with Shift, straight horizontal or vertical.

Guide

Thread dimensioning per ISO 6410

A thread is not drawn with its actual profile: it is shown in simplified form and all the information goes in the callout. With a complete designation the shop knows which tap, insert and gauge to use without asking.

1

How it is drawn

On an external thread the crest is a thick line and the root a thin line. On an internal thread shown in section it is the other way round: the drilled hole in thick and the nominal diameter in thin. In the end view the thin line is a circle with roughly a quarter missing. The end of the useful thread is marked with a thick line.

2

The designation

Always dimension the nominal diameter, never the root. For coarse metric threads «M20» is enough; a fine pitch must be added: «M20×1.5». Then comes the tolerance class, «M20×1.5 - 6g» on a shaft or «6H» in a hole. If none is given, medium quality (6g and 6H, from M1.6 up) is assumed. A left-hand thread ends with «LH».

3

The length

Dimension the useful thread length, up to where the profile is complete, without the tool runout. A thread relief groove is dimensioned separately with its width and diameter. The lead-in chamfer is usually 45° and reaches the thread root.

4

Blind tapped holes

They take two depths: the useful thread depth and the tap drill depth, which is deeper to clear the tap point. For example: «M8 - 6H, thread 16, drill 20». A through hole is stated as such and needs no depth. For several identical holes, dimension one and add the count: «4× M8».

Frequently asked questions

Thread dimensioning FAQ

Do I need to state the pitch on a metric thread?

Only for fine pitch. «M10» is coarse pitch (1.5 mm) and needs nothing else; «M10×1» is fine pitch and must always be stated.

Which tolerance should I use if none was given?

General purpose is 6g for external and 6H for internal threads. It is what applies when the drawing says nothing, but writing it avoids doubts at inspection.

Should the tap drill diameter be dimensioned?

It is not needed: the thread determines it. The shop reads it from the chart (for metric, roughly nominal diameter minus pitch). Its depth is dimensioned in blind holes.

How are pipe or inch threads called out?

With their own designation: «G 1/2» for parallel pipe thread, «R 1/2» for taper, «1/2-13 UNC» for unified. The representation on the drawing is the same as for metric.

Which standard covers thread representation?

ISO 6410-1 defines how threads are drawn and dimensioned on drawings. Metric thread designation and tolerances are in ISO 965-1.

Keep going

Related apps