Mazak 130-136 alarm: Mode, feed, spindle or start interlock

Mazak detects invalid operating condition: no mode, zero feed, spindle stopped/exceeded or start lock. It is an alarm from the Program area, and in the catalog it is listed as “Mode, feed, spindle or start interlock”. On the machine you notice it like this: The block does not start, feed/spindle/start interlock message, May appear when starting from mid-program.

On the shop floor it almost always comes from one of these causes: Modo incorrecto, Override a cero, Spindle not ready, Interlock de corte activo, Security condition pending. Rule out the most likely one on your machine first, before touching parameters or swapping anything.

Reset tras cumplir condiciones de arranque. Resetting without fixing the cause first only hides the problem: Mazak 130-136 trips again and, in the meantime, you keep working with the machine in bad shape.

With the machine stopped and in a safe state, start with these checks: Check the mode, the overrides and S/M, Check start signals, Return to safe start. That alone will tell you whether it is the program or whether you need to raise a maintenance job.

With Mazak 130-136 active, avoid this: Do not bypass safety devices, Do not manipulate energized electrical cabinet, Do not continue producing if the alarm reappears. Skipping any of these points is what turns a minor stop into an expensive breakdown.

If the condition does not change in diagnosis or it is PLC/OEM. If you are not sure how far it goes, stop the machine and report it: a repeat alarm always works out cheaper than a crash.

It is a stop alarm: the cycle will not continue until you fix the cause. It does not always mean serious damage, but it leaves the machine where it is and you have to check it before running again. Guidance reference. Always confirm the full text in the exact machine/control manual.