The revolution counter
The small pointer counts the full turns of the large one. On a 0.01 mm indicator, each turn is 1 mm: if it's past the 3, that's 3 mm.
Learn to read a dial indicator: the large pointer and the revolution counter. 0.01 mm, 0.002 mm and inch (0.001") indicators. Practice with random readings and learn to use it to center parts and measure deviations.
Turn the needle with your finger or push the plunger.
How to read this measurement
Step by step
The small pointer counts the full turns of the large one. On a 0.01 mm indicator, each turn is 1 mm: if it's past the 3, that's 3 mm.
Each division on the dial equals the resolution (0.01 mm on the most common one). Read the divisions from 0: if it's on 47, that's 0.47 mm.
As an absolute measurement: 3 + 0.47 = 3.47 mm. But a dial indicator is almost always used to compare: you zero it on a reference and read how much the part deviates.
Before measuring
Mount the indicator with the plunger already pressed in half a turn or one. If you leave it right at the stop, you won't see it when the part goes lower.
The stylus has to be perpendicular to the surface. Tilted, it reads high (cosine error): at 20° the error is already 6 %.
A long arm or a loose magnetic base moves, and the indicator reads it as if it were the part. Use the shortest arm you can.
As with the caliper, look at the dial straight on: the pointer sits a few millimeters above the lines.
Questions
The small pointer gives the whole millimeters (one turn of the large one = 1 mm) and the large one, the hundredths: each division is 0.01 mm. Example: small pointer past the 2 and large one on 35 = 2.35 mm.
To center parts in the chuck, align the vise, measure the eccentricity or runout of a shaft and compare parts against a reference one. What matters is the difference between two readings, not the reading itself.
A dial indicator has a straight plunger and measures along its axis; a lever-type (dial test indicator) is smaller and fits into tight spots, but has less travel and you have to correct for the stylus angle.
According to ISO 463, a 0.01 mm dial indicator with 10 mm of travel has an error of around ±10–15 µm over the full travel, but much less within one revolution. That's why it's used to compare over short travels.
Where the data comes from
The data on this page comes from these standards and catalogs. If you see a figure that doesn't match your catalog, write to us and we'll check it.
Learn to read an outside micrometer in 0.01 mm, 0.001 mm with vernier or in inches: turn the thimble, check the sleeve and the half millimeter, and practice with 10 random measurements.
Learn to read a vernier caliper with 0.1, 0.05 and 0.02 mm verniers or in inches: move the slider, find the matching line and practice with 10 random measurements. Free, in your browser.
Works out ΔL with α corrected for the temperature you work at, corrects a reading to 20 °C using the part and the instrument you measured with, tells you how far to heat the bore or chill the shaft to fit, and how long to wait before measuring.
We use technical and security cookies and, only if you accept, analytics with no cross-site tracking. More in the Cookie policy and Privacy policy.
We use first-party cookies and technical storage to make the site work, Google reCAPTCHA security technology and, only if you accept, Vercel analytics (no cookies, no cross-site tracking). You can accept or reject analytics; both options are equivalent and you can change your choice at any time. More info: Cookie policy, Privacy policy, Legal notice and Terms and conditions.