Okuma 5060 alarm: Servo overload

Okuma OSP detects excessive servo/axis load. It is an alarm from the Servo / ejes area, and in the catalog it is listed as “Servo overload”. On the machine you notice it like this: Under load alarm, The axis may run hot, Movimiento pesado.

On the shop floor it almost always comes from one of these causes: Corte excesivo, Dry guides, Rodamiento/acoplamiento, Servo/drive. Rule out the most likely one on your machine first, before touching parameters or swapping anything.

Reset after removing load and confirming free axis. Resetting without fixing the cause first only hides the problem: Okuma 5060 trips again and, in the meantime, you keep working with the machine in bad shape.

With the machine stopped and in a safe state, start with these checks: Reducir carga, Check lubrication, Check if it occurs in vacuum. That alone will tell you whether it is the program or whether you need to raise a maintenance job.

With Okuma 5060 active, avoid this: Do not bypass safety devices, Do not manipulate energized electrical cabinet, Do not continue producing if the alarm reappears. Skipping any of these points is what turns a minor stop into an expensive breakdown.

If it occurs without load or there is mechanical hardness. If you are not sure how far it goes, stop the machine and report it: a repeat alarm always works out cheaper than a crash.

It is critical: there is a real risk of damage to the machine, the tool or a person. Leave the machine stopped, do not keep resetting it to see if it goes away, and call maintenance before producing again. Guidance reference. Always confirm the full text in the exact machine/control manual.